how to extrude faces with group?
2379 7 0- g2mXagent
- Member
- 10 posts
- Joined: March 2014
- Offline
- BabaJ
- Member
- 2024 posts
- Joined: Sept. 2015
- Offline
- osong
- Member
- 248 posts
- Joined: May 2017
- Offline
- BabaJ
- Member
- 2024 posts
- Joined: Sept. 2015
- Offline
The reason I did it that way is because the question was “by group”.
Essentially showing you how by grouping you can achieve unique results per group;
e.i. each group gets its' own polyextrude.
Yes it's complicated if your going to drive them all with the same values, but not if each are individualized.
Could really all be done in a single wrangle node.
Essentially showing you how by grouping you can achieve unique results per group;
e.i. each group gets its' own polyextrude.
Yes it's complicated if your going to drive them all with the same values, but not if each are individualized.
Could really all be done in a single wrangle node.
- g2mXagent
- Member
- 10 posts
- Joined: March 2014
- Offline
- osong
- Member
- 248 posts
- Joined: May 2017
- Offline
BabaJhey, no worries. I technically solved it by group as well, so we are both not wrong. In no way I wanted to undermine/minimize your effort.
The reason I did it that way is because the question was “by group”.
Essentially showing you how by grouping you can achieve unique results per group;
e.i. each group gets its' own polyextrude.
Yes it's complicated if your going to drive them all with the same values, but not if each are individualized.
Could really all be done in a single wrangle node.
Edited by osong - April 18, 2018 03:07:14
- BabaJ
- Member
- 2024 posts
- Joined: Sept. 2015
- Offline
- vusta
- Member
- 555 posts
- Joined: Feb. 2017
- Offline
-
- Quick Links