Hey Houdini Forums,

Is there an edge loop / edge ring command in Houdini that will allow me to select multiple edge loops or edge rings based on component selection?

The A key only lets me select edge loops one at a time.

If I have Loop A start / end edge selected
Loop B start / end edge selected
select edge loop command -> 2 partial edge loops selected


The same for edge ring.


Also in houdini for Poly Bevel is there a way to remap mouse wheel width to mmb drag and increments to shift MMB. This is more friendly for wacom tablet users than the mouse wheel. ???


In python it might be like if active tool = polyBevel, mmb = polybevel.increments?
I'm very bad at python, I had scripts in maya but they are very basic. Much harder to figure out python in houdini without active listener.

Thanks