Hello everyone, I have my procedural tree and I would like to add a wire simulation to it. The problem I have is - that for the wire sim I need lines in the middle of my geometry. If my branches wouldn't be so thin and close to each other I could just scatter points on the surface, fuse and then connect them. But when my branches are so thin and so close to each other that I run into a problem where I can't find a way to have a wire in middle.
I am using L-systems for my procedural tree and maybe there is a way to get my skeleton information even though I am using Tubed type ? Or maybe there is another way how I could create lines so I could use vellum solver or wire solver later to simulate it ?
I am attaching picture of my WIP tree, so you could visualize it.
Thank you in advance