Chain SOP - keep geo vertical along curve
829 2 1- papsphilip
- Member
- 383 posts
- Joined: July 2018
- Offline
i want to have a piece of geo copied and deformed appropriately along a curve, but remain vertical.
Using the orient along curve i get halfway there, but then my geo gets squished at certain areas of the curve.
Essentially my geo has the correct orientation along the curve but has lost its width
In what way do i need to setup the normals so that the result is correct?
Using the orient along curve i get halfway there, but then my geo gets squished at certain areas of the curve.
Essentially my geo has the correct orientation along the curve but has lost its width
In what way do i need to setup the normals so that the result is correct?
- Aizatulin
- Member
- 470 posts
- Joined: July 2005
- Offline
- papsphilip
- Member
- 383 posts
- Joined: July 2018
- Offline
-
- Quick Links