intensityMult: intensityMult: Intensity adjustment relative to the dome intensity. This gets multiplied by the parent dome light’s intensity and power.
tint: tint: This parameter tints the color from the dome texture.
colorMapGamma: colorMapGamma: Gamma-correct the texture.
colorMapSaturation: colorMapSaturation: Adjust the texture’s saturation.
enableTemperature: enableTemperature: Turns color temperature on or off.
temperature: temperature: Allow the user to choose the color temperature of the light in Kelvins. This control will act like a filter (a tinted transparent surface) in front of your light. If your light is white, you will get the chosen color temperature. If your light is colored, the color temperature will make it cooler (over 6500K) or warmer (below 6500K). NOTE: The effect will be less pronounced on fully saturated mono-chromatic lights. Defaults to 6500 K, the D65 illuminant (white point) used by sRGB and Rec. 709.
specular: specular: Amount of specular light that is emitted. This is a non-physical control. You could use a light with Specular Amount 0.0 to act purely as a source of diffuse light for your scene objects and avoid adding highlights.
diffuse: diffuse: Amount of diffuse light that is emitted. This is a non-physical control. You could use a light with Diffuse Amount 0.0 to act purely as a source of highlights for your scene objects.
enableShadows: enableShadows: Enable raytraced shadows.
shadowColor: shadowColor: The color of the shadows cast by emitted light.
shadowDistance: shadowDistance: The maximum distance of the shadow starting from the position of the point being shaded. -1.0 is unset which will use the distance between the point being shaded and the point on the light. You may use this control to artificially reduce the distance shadows are cast. This may also increase render speed by not calculating shadows outside this distance.
shadowFalloff: shadowFalloff: the distance from the light at which shadow falloff begins. -1.0 turns off shadow falloff. This is used along with Shadow Max Distance to create a false fade for shadows that are reduced or cut off by the Shadow Max Distance parameter. Note this parameter may impact performance on complex lighting setups.
shadowFalloffGamma: shadowFalloffGamma: The gamma of the shadow strength in the falloff zone. This requires the use of Shadow Max Distance and Shadow Falloff.
shadowSubset: shadowSubset: Set of geometry to consider for traced shadow intersection. If this is not specified, all geometry are considered for traced shadow intersection.
shadowExcludeSubset: shadowExcludeSubset: Set of geometry to ignore for traced shadow intersection. If this is not specified, all geometry is used for traced shadow intersection.
traceLightPaths: traceLightPaths: Enable light and photon tracing from this light. This value enforces a physically-based light and as a side-effect disables the above Shadows controls. Users may use this feature to selectively decide which lights emit photons when using the PxrVCM or PxrUPBP Integrators.
thinShadow: thinShadow: Enable thin shadow and disable refraction caustics for this light. This parameter will ignored if Trace Light Paths is enabled. This is a non-physical control that creates 'fake' colored shadows for transmissive objects without needing to generate photons for caustics.
fixedSampleCount: fixedSampleCount: Specifies an override of the number of light samples to be taken for this light source. If set to something other than zero, it will override the sampling performed by the integrator. You might find need for this if you have unsolvable noise from this light and need more samples.
lightGroup: lightGroup: Specify the light group name used for light group LPEs. This is useful to generate per-light AOVs for later adjustment in compositing
importanceMultiplier: Importance of this light for noise control.