I'm using a Sequential Blend SOP for n parameters. I'd like to create a waveform that steps up smoothly to each parameter 0 - n-1 holding for a bit at each integer value. A rough pic of the kind of waveform I'd want to create below.

Any and all suggestions greatly appreciated!!!

Greg

Find CHOP drive deform file on Odforce forum or Here on Forum. Use Quantize!

cncverkstad
Find CHOP drive deform file on Odforce forum or Here on Forum. Use Quantize!

I couldn't find either of those references. Could you post a link?

Also, I found a partially procedural solution. I animated a point along that curve above with a Carve SOP (animating the U percent) then used P.y to generate the values 0-2. This is ok-ish except I have to construct the curve differently for the number of variations of an attribute I want to blend. The above curve works for 3 versions of an attribute.

Any ideas for a fully procedural technique?

Cheers,
Greg