|On this page|
Builds a bump map from an image. The bump map can either be created as a new plane, or it can replace the plane it was built from.
A bump map is built by detecting luminance edges in the image. These edges become the bumps. The effect can be scaled up to mimic the effect of a rough surface, or reduced to add only a slight amount of lighting variation.
Bump maps can be used by the Lighting COP to produce semi-realistic lighting on ordinary images.
The bumps are computed by variations in luminance; this determines how to compute that luminance.
Scales the bumps after generation.
Simple Bump Map
If on, only 5 pixels are used to determine the bump map, otherwise all 8 neighbors plus the current pixel is used.
Generate Bump Map
If on, instead of converting planes to bump maps, a source plane is used and the output bump map is added to the plane list.
The plane to use as the bump source.
The name of the new bump plane, if a new plane is being generated.
Specifies the scope for both the RGB components of Color, Alpha, and other planes. The (C)RGBA mask only affects Color components and Alpha. 'C' will toggle all the RGB components.
For planes other than Color and Alpha, the plane name (plus component, if applicable) should be specified in the string field. The pulldown menu can be used to select planes or components present in this node.
A plane is specified by its name. A component is specified by both its plane and component name. The '*' wildcard may be used to scope all extra planes. Any number of planes or components can be specified, separated by spaces.
P N.x N.y P N Pz
Allows scoping of specific frames in the frame range. This is in addition to the plane scope (so a plane at a certain frame must be both plane scoped and frame scoped to be modified).
All frames are scoped.
All frames inside a subrange are scoped.
All frames outside a subrange are scoped.
Even numbered frames are scoped.
Odd numbered frames are scoped.
A user-defined list of frames are scoped.
For Inside/Outside range, this parameter specifies the subrange of the sequence to scope (or unscope). This can be edited in Timeline viewer mode (⌃ Ctrl + 2 in viewer).
For Inside/Outside Range, this parameter specifies certain number of frames before and after to slowly ramp up to scoped. The operation will be blended with its input to 'ease in' or 'ease out' the scoping effect over a number of frames. This can be edited in Timeline viewer mode (⌃ Ctrl + 2 in viewer).
For unscoped frames, this sets the blend factor between the input and modified images. Normally this is zero (use the input image). By setting this to a non-zero value, you can make unscoped frames be 'slightly' unscoped. The value can vary between 0 (unscoped) and 1 (scoped).
The frame list for 'Specific Frames'. Frame numbers should be separated by spaces.
Automatically Adjust for Length Changes
If the sequence range changes, enabling this parameter will adjust the subrange and frame dropoff lengths to fit the new range.
Start of sequence
End of sequence
Input sequence length
Sequence frame rate
Number of planes in sequence
Width and height of image
Image index (0 at start frame)
Image time (0 at start frame)
Current plane array index
Current plane index
Num of channels in current plane
Composite Project X resolution
Composite Project Y resolution
Composite Project pixel aspect ratio
Composite Project raster depth
Composite Project black point
Composite Project white point
The following examples include this node.