just trying to work out how to place different modular sections on a curve. placing them on points is not working for me, as they only line up if the curve is strait.
Full Version: (Solved)Trying to sweep modular pieces on curve?
Hi guys
just trying to work out how to place different modular sections on a curve. placing them on points is not working for me, as they only line up if the curve is strait.
just trying to work out how to place different modular sections on a curve. placing them on points is not working for me, as they only line up if the curve is strait.
Hi Getyamamout, have you looked into the chain node yet?
https://www.sidefx.com/docs/houdini/nodes/sop/chain.html [www.sidefx.com]
It "repeats one or more pieces of geometry along a curve".
https://www.sidefx.com/docs/houdini/nodes/sop/chain.html [www.sidefx.com]
It "repeats one or more pieces of geometry along a curve".
Ah Konstantin Magnus
Chain is doing a better job just need to have it a bit smoother and let the ends merge into each other a bit
Chain is doing a better job just need to have it a bit smoother and let the ends merge into each other a bit
Ah ha didn't realise I could use more points on the curve, with this node to get a more rounded look.
And the joint was offset by -3mm in the alignment tab.
And the joint was offset by -3mm in the alignment tab.
Here is the next question... can I use the chain with G-splats???
The chain node should be fine as long as your input is correct.
Thank you for your help Konstantin Magnus.
