So we have an hda that creates a road on a heightfield. We then save the mask to a layer via the Heightfield Copy Layer sop. So we end up with a “road” layer in addition to the usual: height, mask, sediment, bedrock, debris, water.
If we write out a bgeo from the HDA directly we get all the layers:
BUT if we run the HDA from the TOPs network the “road” layer disappears and instead we seem to have 2 empty spots:
How do we go about debugging this? There is no error that's being thrown and the HDA is being processed, we check the time stamp. Here are the HDA Processor Parameters:
On a sidenote but somewhat related: Where does the debugging script you can enable from the HDA Processor get saved to? Could not find it in the Output file folder. Does it go somewhere else?
Thank you