Ömer Furtun

sepu
use the blend attribute.

Hi,

I was also wondering the same question as OP, could you elaborate on using this?

I can't seem to get this to work with height attribute, can't seem to figure out what I'm missing.

Hello, I wanted to share my experience.

I'm using a Ryzen 9 5900x on a B550 Tomahawk MAG motherboard.

CPU is being cooled by an ARCTIC Freezer 34 eSports DUO air cooler.

My case is mid-tower with 2x140mm Arctic F14 intakes at the front and 1x120mm Arctic F12 exhaust at the rear.

I have an RTX 3080 in the system.

My max temps are 80 degrees Celsius on CPU and 70 on GPU; idle temps are 45 and 48 degrees respectively.

Fan RPM is limited to 70% to %75 on all fans up until these max temps.

I set the fans to go faster if any of these temps rise above 80 degrees. But they almost never do.

When idle, intake fans run at 20% RPM, exhaust runs at 25% RPM and CPU coolers run at 30% RPM. GPU fans stop completely.

This setup is utterly silent when idling and very quiet under max load.

I literally don't hear anything while turning on or while idling.

While rendering I tend to take a nap on my office couch. I have to look at the screen to tell if the operation is still going.

The case is not a silent padded case. It's a regular airflow case with mesh paneling. Nothing fancy.

I'm also using an old 750W Bronze rated PSU. I replaced its 140mm fan with the same Arctic F14 intake fans so I could PWM control the PSU fan to run silent.

Hope this was helpful.