This operator computes the square root of the argument.
The following examples include this node.
This example simulates grass being pushed down by an RBD object. Fur Objects are used to represent the blades of grass and Wire Objects are used to simulate the motion. When a single Fur Object is used to represent the grass, neighbouring blades of grass will have similar motion. Additional objects with different stiffness values can be used to make the motion less uniform. When "Complex Mode" is enabled, two objects are used to represent the grass. The stiffness of each set of curves can be controlled by adjusting the "Angular Spring Constant" and "Linear Spring Constant" parameters on the corresponding Wire Objects.
No geometry is animated in this file. All animation is achieved by animating the textures
Flames are grids so that UV textures can easily be applied, they are then warped around a metaball using a magnet SOP. The flames are then assigned to either a yellow or blue Flames texture. The Flames' opacity mask wrap is set to Decal to prevent the texture from repeating and showing a single pixel ring at the top of the flame geometry. I'm also using a mask file named
flameOpacMap.jpg to enhance the flames' shape at the top. The noise offset has been animated over
$T with an greater emphasis on the Y axis so that the flames look like they are rising. This is the same reason the Noise jitter is larger for the Y axis as well.
The coals are spheres that have been copy stamped onto a deformed grid. Using Attribute Create surface nodes I am able to override and copy stamp the lava texture’s parameters at the SOP level so that local variables, such as
$BBY, can be used to animate the texture. This way the texture’s crust and its crust values can be used only to form the tops of the coals. This reserves the lava aspect of the texture to be used on the bottoms of the coals. The lava intensity (
Kd attribute) is then stamped and animated to create the look of embers on the bottom of coals glowing.