mouse_art

mouse_art

About Me

Expertise
Not Specified
Location
Not Specified
Website

Connect

Recent Forum Posts

Poly extrude along curve June 20, 2018, 6:09 p.m.

Actually i don't know if it even shoul'd be on the curve. (But i am a starter…and i don't know many nodes yet.)
Anyway here is your Scene file re-saved as *.hipnc(sorry only Apprentice here) with one added switch node, state 0 is a grid(a face) extruded along curve1(through a sweep node and some other nodes(inside the subnet).

Hope this helps somewhat.
Image Not Found

Modelling and some consideration March 6, 2014, 2:37 p.m.

Yep modeling operations are handled in the operator stack and undo system, selections undo.

Problems with Bullet solver July 27, 2012, 11:27 p.m.

I did a similar mistake, i messed up one of my PolygonSplit operations, the result was the same, the collision didn't work properly on the column.
I backtracked every node in the column tree with bypassing them until i found my bad node…

Maybe i could just have rebuilt the entire thing faster, but i learned something from it.