So I want to make the smoke fill the spiral tube and I'm pretty close to result I've been aiming for but i've run into a problem I can't seem to resolve. Here is the problem I'm talking about:
At the end you can see that the smoke stops being affected by turbulance and curve force.
Video of the same file with curve force turned off(still something starts to go wrong at the same point as in the first video)
I attached 2 screenshots that may help understand the problem.
I would really appriciate some help with this, I've been trying to fix that for quite a time now and I just can't figure out whats wrong with my set up…