Why does my poly extrude mess up my point numbers
1199 3 1- plagelpuss
- Member
- 11 posts
- Joined: Nov. 2017
- Offline
- BabaJ
- Member
- 2038 posts
- Joined: Sept. 2015
- Offline
- plagelpuss
- Member
- 11 posts
- Joined: Nov. 2017
- Offline
I am poly extruding a sweep to get 3d shape, but extrude gives me a stepped result. I am trying to loop over the points using a wrangle node so that I can try to average out the point locations. once the poionts are stacked i was going to try to fuse the points that are in the same position.
basically I want to get the left side to look like the right side.
basically I want to get the left side to look like the right side.
- plagelpuss
- Member
- 11 posts
- Joined: Nov. 2017
- Offline
-
- Quick Links