Just watching the Group tutorials by SideFX and I'm seeing that the Group Create node doesn't have these same options.
Thanks for any direction you can give!
Where did the Group by Numbers and the Pattern options go?
11448 6 1- tranasaurus
- Member
- 43 posts
- Joined: Nov. 2016
- Offline
- edward
- Member
- 7725 posts
- Joined: July 2005
- Offline
- thetarahashmi
- Member
- 2 posts
- Joined: Nov. 2016
- Offline
The Group Expression node only works with VEX expressions. What is the direct replacement for Group by Pattern where I can use ‘0 $N’. I tried putting it into the Base Group section in the Group node to adjust edges (as per Rohan's Mograph Tutorial) and it only scales 1 edge opposed to 2. Any suggestions?
- Doudini
- Member
- 333 posts
- Joined: Oct. 2012
- Offline
instead of using $N i think you could use
`npoints(opinputpath(“.”, 0))-1`
also there is this vex snippet for selecting end points by checking how many neighbours the point has:
just add group_ends to the attributes to create and it will create a group.
hope it helps.
edit: you can also usein the groupexpression SOP.
or:to simulate the 0 $N
`npoints(opinputpath(“.”, 0))-1`
also there is this vex snippet for selecting end points by checking how many neighbours the point has:
@group_ends = (neighbourcount(0,@ptnum) == 1);
just add group_ends to the attributes to create and it will create a group.
hope it helps.
edit: you can also use
neighbourcount(0,@ptnum) == 1
or:
@ptnum == 0 || @ptnum == @numpt-1
Edited by Doudini - Feb. 25, 2017 22:07:18
- edward
- Member
- 7725 posts
- Joined: July 2005
- Offline
- zuleikaf
- Member
- 2 posts
- Joined: April 2017
- Offline
- robmoggach
- Member
- 2 posts
- Joined: Oct. 2009
- Offline
-
- Quick Links