Carve with Random

   1015   2   0
User Avatar
Member
45 posts
Joined: Feb. 2017
Offline
Hey Everybody,
I just wanted to share this setup.
I was searching for a way to carve multiple curves with a random offset in one go.
I didn't want to use a loop so this is vex and sops.
mostly an exercise for myself, but maybe useful to somebody.
Cheers
CYTE
Edited by CYTE - June 21, 2017 10:49:56

Attachments:
CarveWithRand.hip (100.3 KB)

User Avatar
Member
24 posts
Joined: Aug. 2006
Offline
Thanks this was very helpful. I often use a workflow that requires points crawling on curves, and a simplified version of this does that much more efficiently than any of the 4 methods I used prior.
User Avatar
Member
115 posts
Joined: Feb. 2017
Offline
if you look at the end result….12 lines…that should be roughly say 50 points all up…but look at the spreadsheet and there's over a thousand of them.

sure, stick in a fuse, simple….but fundamentally, to me it shouldn't get to the situation where you have thousands of points (piling up at starts/ends) then having to fuse them.
  • Quick Links